Magic 8 Ball
Firmware for the Waveshare ESP32-S3-LCD-1.28. Plug the board in with a USB-C data cable and install it straight from this page.
Loading version…
Installing
- Connect the board to your computer with a USB-C cable that carries data (charge-only cables won't show up).
- Click Install firmware and pick the board's port from the list. It usually shows as USB Single Serial or CH343.
- Click Install and wait for it to finish, about a minute.
- Unplug and replug, or tap RESET. Shake the ball and set it down.
If it doesn't connect
No port in the list
Try another cable. On Windows, the board's USB chip (CH343) may need its driver from Windows Update.
Stuck on "Connecting"
Hold BOOT, tap RESET, let go of BOOT, then click Install again.
Screen stays dark after install
Tap RESET. The intro fades in over about a second.
Port busy
Close Arduino IDE's Serial Monitor or anything else using the port.